DC 安定化 電源 電源 使用法 プロセス
(1) ターン オン 電源 電源 ジャスト 接続 調整 電源 電源 から 回路。
(2) ターン オン 電源 電源. イン ケース of 無負荷 接続, 押す メイン 電源 スイッチ, and then turn on the DC output switch of the power supply to make the power supply work normally (some simple adjustable regulated power supplies only have a main power switch and no independent DC output switch). At this time, the current operating voltage and output current are displayed on the power digital indicator.
(3) By adjusting the voltage setting knob, the digital voltmeter can display the target voltage and complete the voltage setting. For power supplies with adjustable current limiting, there are two sets of regulation systems that regulate voltage and current each. When adjusting, the distinction should be made clearly. And pay attention to the word "VOLTAGE" on the voltage potentiometer. potentiometer for current adjustment 通常 has the word "CURRENT"です。
(4) 電流 設定 押す および ホールド "Limit" オン 電源 ストリップ for a while, the 電流計 意志 表示 電流 value, and control the current by 調整 the current knob. 通常
and hold the "Limit" button on the power panel. At this time, the ammeter will display the current value. Adjust the current knob to make the current value reach the predetermined level. General, the current limit can be set on the 120 power supply with the highest current. There is no special adjustment key for limited current. ユーザー ニーズ に 短絡 に 出力 に に 指示, and then set the current limit level according to the-short-circuit current and the current limit knob. The simple adjustable voltage-stabilized power supply does not have a current setting function or a corresponding knob.
(5) 過電圧 保護 OVP 設定 過電圧 設定 参照 に さらに 制限 上限 制限 電圧 内 調整可能 電圧 範囲 の 電源 電源 自体 に 防止 電源 供給 から 出力 過剰 電圧 中 誤操作。
過電圧 設定 参照 に さらに 制限 an 上限 制限 電圧 within the adjustable voltage range of the power supply itself to prevent the power supply from outputting excessive voltage during misoperation. When setting the OVP voltage, first adjust the power supply operating voltage to the target overvoltage point, and then slowly adjust the OVP potentiometer to make the power supply protection just act. At this time, the OVP has 決定されました. それから, turn off the power, reduce the operating voltage, and you can work normally.
(6) コミュニケーション インターフェイス パラメータ 設定 および リモート コントロール 操作 setting. For local control (panel operation) applications, remote control operation should be turned off. The communication interface should be set according to the communication requirements, but not the local application.
